Since 1968Done once. Done right.Bonds you can trust
Subfloor & Deck
LN-902 VOC-Compliant Subfloor Adhesive, 10 oz
10 oz cartridge
$4.68
★★★★☆ 4.2 out of 5 · 138 ratings
The VOC-compliant, low-solvent LN-902 in the 10 oz cartridge, recommended for bonding wet, frozen, engineered and treated lumber, OSB, plywood, particleboard and wafer board. Instant holding power for interior and exterior work, and it meets the American Plywood Association AFG-01 specification that glued floor systems call for.
BondsWet, frozen, engineered and treated lumber, OSB, plywood, particleboard and wafer board, subfloors, decks and sheathing, interior and exterior.
Price and stock are shown on the partner store page that opens from the button.
Guns at 20 degrees F
Wet & frozen lumber
Stops floor squeaks
Bridges gaps
Bonds wet, frozen, engineered and treated lumber
OSB, plywood, particleboard and wafer board
Interior and exterior formula with instant holding power
Meets the APA AFG-01 subfloor adhesive specification
VOC compliant, low solvent
Reaches for it
Engineered I-joist floorsDeck repairsShed floorsTrailer and porch decks
Brush debris, snow and ice off the joists; the adhesive bonds to wet and frozen lumber.
Cut the tip for a 1/4 in. bead and puncture the seal.
Run a continuous bead down the center of each joist, two beads where panel ends meet.
Lay the panel within the working time and fasten immediately per the panel schedule.
Keep traffic off 24 hours; full cure 7 days.
Not recommended for mirrors, ceramics or non-porous plastics.
Specifications
Size
10 oz cartridge
Color
Tan
Specification
APA AFG-01
Base
Low solvent, VOC compliant
Base
Solvent-based subfloor construction adhesive
Application temperature
20 to 100 degrees F
Specification
Meets APA AFG-01
Coverage
About 80 linear ft of joist per 28 oz
Service
Interior and exterior
Color
Tan
The spec-sheet subfloor tube, 10 oz. Orders, delivery and returns run through the order page of the partner store.
From the job site
What buyers wrote about this tube
★★★★★
Incredibly strong way to connect concrete blocks.
Pleased to report I successfully used this construction adhesive to create a concrete block connection between my retaining wall and the steps leading up to my house. It was a project I kept putting off (in spite of dirt spilling through the gap between the wall and steps every time it rained, leaving a slippery mess) because I have no practical way of mixing concrete, and didn't realize there were alternative ways of joining rocky surfaces. The adhesive is holding like gangbusters after four weeks of cold, heat and storms (it's Atlanta), and I even step on the blocks from time to time to see if there's any give in the joints. There isn't! And I'm not a small girl... This stuff is so good, I wrote down the name of the product to tuck away for future use.
Book Junkie · April 22, 2025
Questions about this tube
What does AFG-01 certify?
That the adhesive bonds subfloor panels to wet and frozen lumber and holds up under the APA glued floor system tests.
Is VOC-compliant the same as low odor?
It is lower in solvent than the standard formula; for a finished, occupied interior the latex LN-602 is the lowest odor.
